The intelligent pneumatic, handheld screwdriver of the series MICROMAT-F and MINIMAT-F with multi-function control controls itself and safeguards your screwdriving process 100 percent.

After detecting the start signal from the screwdriver (operator push down or start trigger), the air supply to the driver is enabled via the new multi function control fc20 combined with the pneumatic control. When reaching the preset torque value, the screwdriver stops by way of the extremely accurate shut-off clutch. In connection with the pneumatic control and a sensor in the screwdriver the multi function control is able to confirm the correct screw assembly sequence.

The screw tightening time is compared to a minimum/maximum pre-programmed time window. If the screw tightening time is too short (scross thread) or too long (stripped screw) the operator is alerted by a failure message. In addition an onboard sensor confirms that the screwdriver is enabled until the clutch mechanism is disengaged insuring that the cycle was not terminated as a result of the operator lifting the screwdriver prematurely. This confirms that the tightening process was carried out properly without material failures or influence by the operator. In short, the screwdriver with multi function control monitors itself and assures a 100% integrity of your assembly.

In addition, the number of screw assembly operations per part can be controlled. No screw will be forgotten!

The ergonomic screwdrivers in this design series are available in different executions: with straight form for vertical assemblies, with angle-head form for tight access and high-torque requirement, and with a handy pistolgrip for horizontal assemblies.